DALLAS – A train failed to heed a stop signal before it barrelled head-on into another freight train last month in the Texas Panhandle, killing three, according to a preliminary federal report released Thursday.
An eastbound BNSF Railway train failed to slow at a yellow warning signal on June 28 and then continued past a red stop signal before striking an oncoming BNSF train, inspectors for the National Transportation Safety Board said in the report.
The eastbound train, bound for Chicago, was supposed to stop and allow the Los Angeles-bound train to pass. It was travelling just over 60 mph when it passed the yellow signal, though trains are not supposed to travel any faster than 40 mph at a yellow signal so that they can stop in time at a red signal. The train was travelling about 65 mph when it passed the stop signal.
NTSB spokesman Terry Williams said it’s not clear how far beyond the stop signal that the point of impact occurred.
“We’re still in the gathering phase of this investigation,” he said, adding that a final NTSB report will be released at some point next year. He declined to comment further.
The collision occurred outside the town of Panhandle, about 25 miles northeast of Amarillo. Each train was carrying two crew members. One jumped to safety, the other three died.
BNSF estimates the damage at $16 million, according to the report. The eastbound train was pulling 56 loaded cars and the other train had 54 cars — all carrying stacked containers of consumer goods, like paper products, clothing, televisions and computers.
The collision triggered a fireball and caused containers and cars to tumble onto one another in a pileup. Freight cars derailed and were strewn along with containers about 400 yards from the collision site. Authorities have previously said the eastbound train had stopped in Amarillo to refuel, and that diesel fuel contributed to a fire that burned for hours.
The track has since reopened, BNSF spokesman Joe Faust said, and crews are hoping to have all the debris cleared later this month.
It’s unclear why the crew of the eastbound train did not stop at the signal and Faust referred questions about the cause of the wreck to the NTSB.
BNSF has pledged to meet a 2018 federal deadline to adopt positive train control (PTC) technology that relies on GPS, wireless radio and computers to monitor train positions and automatically slow or stop ones that are in danger of colliding, derailing due to excessive speed or about to enter track where crews are working or that is off limits.
A PTC system is scheduled to be operational by BNSF in the area where the collision occurred by the end of this year, the NTSB said in the report.
Last month’s accident was at least the second in recent years involving BNSF trains striking one another. In September 2013, three were involved in a wreck near Amarillo that injured five crew members, according to a separate NTSB report. The federal agency in that incident faulted the crew in one train for improperly proceeding past a signal and striking the rear of a stationary train.
Follow David Warren on Twitter at: http://twitter.com/WarrenJourno .